Defi-Link Display Function

Function

Operation Status Transition Diagram

Display

Triple Warning Mode is not available when connected to Defi-Link Meter BF.

Only Speed Mode is available if there are no sensors connected to the Defi-Link Control Unit II or Defi-Link Control Unit. In addition, Peak Mode and Replay Mode will not function.

Be sure to connect the speed signal wire when using this product.

Modes

Set up Mode

Allows setting units and display data parameter.

Warning Set up mode

Allows setting of warnings for meters connected to Defi-Link Control Unit II or Control Unit.

Gauge mode

Displays actual vehicle data and speed data for meters connected to Defi-Link Control Unit II or Defi-Link Control Unit.

Peak memory

Memory replay

Speed mode

Displays the vehicle speed.


Driving	Peak	Memory replay

Triple Warning mode

Displays a warning when the Tachometer exceeds the engine RPM set warning value.


No warning	Warning1 (over 9,000 RPM)	Warning2 (over 10,000 RPM)

Replay & peak display

Records vehicle data for meter connected to Defi-Link Control Unit II or Defi-Link Control Unit or it replays the recorded data or displays data peaks.


Record or replay	Peak

Special display mode

Appears when speed is 0km/h or 0MPH for more than 10 seconds.

Warm-up mode

Monitors water temperature until it reaches a set value.


Warm-up	Warm-up done

Self diagnosis mode

Displays serial errors, opens and shorts for each sensor of meters connected to Defi-Link Control Unit II or Defi-Link Control Unit when ignition is on.