Specifications
| Power supply voltage |
10V to 16V DC (12V vehicle only) |
| Current consumption | Maximum during 7 gauges are connected +B (battery) line 2A(IGN ON), 1mA(IGN OFF) +ILM (illumination) line 5mA |
| Illumination color | Switch unit：white (while illumination is on) Switch unit differential pressure LED：blue |
| Applicable number of cylinders | 1, 2, 3, 4, 5, 6, and 8 |
| Illumination input | 1) Illumination signal（12V wire while small lamp is on) 2) Illumination control signal range frequency range： 50～300Hz voltage range： 5～16V minimum pulse width： 0.2msec and above |
| Note | *Products is for only on vehicles with a 12V electrical system. Never use products on 24V vehicles. *Products can not be installed in altered vehicles. *To install pressure gauges or temperature gauges, proper sensor attachments are necessary. The thread sizes of sensors are 1/8PT. |
Components
Part names and dimensions
Differences between DF177 series and DF077 series
| Product No. | Product name |
| DF07701 DF07703 |
Defi-Link ADVANCE Control Unit (EOL) |
| DF17701 DF17702 DF17703 |
Defi-Link ADVANCE Control Unit SE |
| Item | DF07701 | DF07703 | DF17701 | DF17702 | DF17703 | |
| Appearance | Unit panel design (lower right mark) | None | 03 | SE/SE BLK | SE SKY | SE SAKURA |
| Color of the DC source wiring check LED | Blue | White | Light blue | Pink | ||
| Color of the case | Black | Gray | ||||
| Switch panel design | See the figure below. | |||||
| Function | Three minutes record and replay | Available | Not available | |||
| Clock display when ADVANCE FD/ZD is connected | Available in ZD | Not available | ||||
| Stopping oil pressure warning buzzer ※1 | Not available | Available | ||||
| Illumination control signal input ※2 | Not available (Available with CAN Driver) |
Available | ||||
※1 Even if oil pressure indicates 0kPa during idling stop, etc., the oil pressure warning buzzer can be prevented from sounding by setting the value to 0kPa with the DF177..
※2 In vehicles equipped with illumination control (vehicles with pulse-controlled illumination signals, such as European vehicles), the ADVANCE CAN Driver is necessary to make the illumination of Defi gauges work properly with the DF077 unit, but the DF177 unit allows the illumination control signal of vehicle to be input as an illumination on/off signal to the ADVANCE system.
