Functions
Functions listed below with "#" marks are available when the Defi-Link VSD Concept is connected to Defi-Link Control Unit II (or Defi-Link Control Unit) and sensors are connected.
|
Digital and bar display |
||||||||||||||||||||||||||
Data on turbo or boost cannot be displayed. |
||||||||||||||||||||||||||
| Warning display (LED and digital display) # | ||||||||||||||||||||||||||
| Warning values can be set discretionary. Double warning of engine speed is also settable by equipping two LED indicators. | ||||||||||||||||||||||||||
| Record and Replay # | ||||||||||||||||||||||||||
| Connected sensor data and speed data can be recorded for a maximum of 3 minutes. The data can be replayed later. | ||||||||||||||||||||||||||
| Auto Warning # | ||||||||||||||||||||||||||
| When a non-displayed value exceeds the set value, the display changes from selected data to the current warning value automatically. | ||||||||||||||||||||||||||
| Opening/Ending display | ||||||||||||||||||||||||||
| Opening and ending modes are performed after the ignition key is turned on and off. | ||||||||||||||||||||||||||
| Automatic illumination control | ||||||||||||||||||||||||||
| The brightness is adjusted automatically.
Auto dimmer mode and manual dimmer mode are available. When the auto dimmer mode is selected, the brightness of display is adjusted automatically depending on the outside light. The brightness can be selected from 3stages. When the manual dimmer mode is selected, the brightness of display is fixed. The brightness can be selected from 5 stages.
|
||||||||||||||||||||||||||
| Special display | ||||||||||||||||||||||||||
| When a state with a speed of 0km/h or 0MPH continues for more than 10 seconds, special display is played. | ||||||||||||||||||||||||||
| Warm-up display (oil temperature or water temeprature) # | ||||||||||||||||||||||||||
| Oil temperature or water temperature is displayed until the temperature reaches the set value. | ||||||||||||||||||||||||||
| Control out # | ||||||||||||||||||||||||||
| Signals of oil temperature or water temperature can be output when it reaches the set value. It’s possible to operate a warning lamp or a motor when a temperature reaches the set value. | ||||||||||||||||||||||||||
| Peak display # | ||||||||||||||||||||||||||
| Maximum values which sensors are connected are displayed. If speed is recorded, the minimum value can be displayed. | ||||||||||||||||||||||||||
| LINK connectors for Defi-Link Meter # | ||||||||||||||||||||||||||
| D.C.Unit(exclusive unit for Defi-Link Display VSD CONCEPT) has 3 LINK connectors for Defi-Link Meters. | ||||||||||||||||||||||||||
Wiring
Wiring example of Defi-Link VSD Concept and Defi-Link System
Defi-Link Display VSD CONCEPT can operate independently.
EXAMPLES OF DISPLAYS
When the Defi-Link VSD Concept is used WITHOUT the Defi-Link System
 Speed/Engine speed |
 Peak display |
 Special display |
When the Defi-Link VSD Concept is connected to the Defi-Link System
 Water temperature # / Engine speed |
 Oil temperature # / Engine speed |
 Oil pressure # / Engine speed |
 Exhaust temperature # / Engine speed |
 Fuel pressure # / Engine speed |
 Speed/Oil pressure # |
 Speed/Fuel pressure # |
 Auto warning |
 Tacho warning |
